Alan,

Either put the appropriate MPE build specs into your ftp 'get' command (for
example, "get  <filespecs> ; REC=xxx; DISC=nnnn; ..."), or alter the file,
BLDPARMS.ARPA.SYS, to accommodate the type of file you're trying to
transfer.

Lee Gunter          [log in to unmask]




From: [log in to unmask] on 06/19/98 12:21 PM

Please respond to [log in to unmask]


To:   [log in to unmask]
cc:    (bcc: Lee Gunter/BCBSO/TBG)
Subject:  ftp hp9000 -> hp3000 of 108mb file




Ok, what do I need to do here????

I'm ftping a file from an hp9000 to the hp3000. It is just a small 108mb
file from Joe G. <thanks Joe>.
Well I'm getting this error:
########################################################################
###
##########################End Of File encountered on target file during
transfer
 Target file not saved.  Increase file limit and try again.  (FTPERR
16)
FTP Unknown Error Detected.  Subsystem = 200, Information = 53  (FTPERR
28)
ftp>
----------------------------------------------
my original get was *both*
get fwtruck.M fwtruck
and when I got the error, I tried.
get fwtruck.M ./fwtruck
So, what can I do here?  And yes it is set to binary and I think I have
enough space on the disk 2.6m sectors = 600mb.
TIA
/alan
[log in to unmask]