Tracy, The settings on the switch pack of our IEM 4430 are Device Address (0-7) on first three switches. For device 5 switches would be up down up. The fourth switch is Offline Request Implementation (Up to reload tape) The fifth and sixth switches are unused The seventh switch is Emulation Mode (Up for 7980 9-track tape, Down for C1511 DDS) The eigth switch is Extended Menu (Up to enable) The 4410 switch pack should be similar. Ken Nutsford Systems Manager Timeshare Systems Ltd -------------Original Message----------------- From: Tracy Johnson, INTERNET:[log in to unmask] To: [unknown], INTERNET:[log in to unmask] Date: 22-08-97 19:37 RE: [HP3000-L] IEM 4410 Rev A Config As you recall ealier in the week I queried about proper configuration of this old DDS drive. Now that I've done that on the HP3000, can someone tell me what the proper dip switch settings should be on the device? It seems the one it used before on the old classic conflicted with my LDEV 3, causing me to reboot with RECOVERY. I found a dip switch setting that doesn't cause my 922 to panic, but I need one that works. I set it up to path 4.1.5 as an LDEV 8 as a C1511A. The test I'm using to see if it works, is to check the console and see if it reports a "TAPE LOADED..." when I put one in. Currently, it doesn't, but the IEM device reports tape at BOT. TIA Tracy Johnson [log in to unmask] "Semper Pollus" ADC-2239-5531