This is two replys in two days that the message disappeared.....

oh well....

here goes again.
---------------------
John Stott said.....

> I am trying to connect HP DTCs ( 16mx's )over a routed IP network; they
> were previously attached on ethernet to a 969. If I turn on bridging on
> my cisco routers, the images load fine and terminals attach right away.
> What I really would like is for the images to load without bridging. I
> read in a manual about Avesta protocol, which is supposed to be
> routable; I'm just not sure how to load up the images on the DTCs using
> routed IP. Any suggestions would be greatly appreciated.

John -

The information on how to set up routable DTC's is in the Communicator for
5.0.

The big drawback as I see it is that you must have a PC running DTC
manager on each IP segment where you have a DTC.

We are just now setting up DTC's across Cisco routers.  Our Vendor says
that there is no problem routing IP and IPX and turning on bridging for
the DTC traffic.

Have you had any performance problems?

/alan
[log in to unmask]