Hi Jeff, Depending on what you really need, you may try the following : 1) Sysgen, io, ld, lp Pro : online, no need to reboot. Just OP cap is needed, in read mode. Con : does not fully address your original concern, unconfigured (i.e. low-level) physical devices not shown, no firmware levels, no PDC/IODC revisions, no CPU/bus frequencies 2) Reboot, select primary path, ODE, run mapper Pro : gives everything you want, hardware components (well, most of them), hardware paths, devices, firmware levels where applicable, and so on. Works for all PA-RISC based systems, i.e. all 3000s and PA-RISC 9000s (excluding Itanium-based Integrity servers). Con : obviously, mandates a reboot. If you need more, such as PDC and IODC revisions, CPU and bus frequencies, etc, these are available during physical reboot (CTRL-B RS) I hope this addresses at least part of your concern. If it does not, please do not hesitate to get back to me, on- or off-list. Season's greetings, Christian, near Paris, France, unemployed at this moment, actively looking > -----Message d'origine----- > De : HP-3000 Systems Discussion [mailto:[log in to unmask]] De la part > de Jeff Kubler > Envoyé : mercredi 2 janvier 2008 16:01 > À : [log in to unmask] > Objet : [HP3000-L] listing of what's in a 996/800? > > >To all; > > Where would be a good place to find a listing of the hardware pieces > that make up a system like a 996/800 or 979 HP 3000 system? > Thanks, > Jeff > > > Jeff Kubler > Kubler Consulting, Inc. > 541-745-7457 > [log in to unmask] > www.kublerconsulting.com > > * To join/leave the list, search archives, change list settings, * > * etc., please visit http://raven.utc.edu/archives/hp3000-l.html * * To join/leave the list, search archives, change list settings, * * etc., please visit http://raven.utc.edu/archives/hp3000-l.html *