Steve, NMMGR is ok if you know tour way around it. An easier way to display it, is to use nettool.net.sys, as below. I have attached part of the output you obtain; you also get gateway information. :nettool.net.sys NETTOOL Version: B06000A1 Enter HELP HELP for an explanation of the help facility. Enter HELP OPERATION for guidance on NETTOOL use. Commands can be abbreviated, HELP keywords cannot. Menu-specific commands for the ROOT: RESOURCE CONFIG NAMEADDR PING STATUS NMDUMP X25STAT X25CHECK IPCINT XPVAL XPPERF QVALNS NSTEST LOOPINIT NSLOGON SOCKINFO filters [1]>> conf;summ >>>summ NM Configuration Manager 32098-20016 B.06.00 (C) Hewlett Packard Co. 1992 Reading commands from "V899418". NMMGR>openconf nmconfig.pub.sys NMMGR>summaryconf netxport NMMGR>summaryconf logging NMMGR>summaryconf link NMMGR>exit END OF PROGRAM CRITICAL SUMMARY - NETXPORT CONFIGURATION WED, JUL 25, 2001, 3:55 PM CONFIGURATION FILE NAME: NMCONFIG.PUB.SYS Unvalidated subsystem. NODE NAME: DOPEY.AUS.HP.COM TRANSPORT GLOBAL CONFIGURATION: Home Network Name: Maximum Inbound Buffer Memory: 1024 Name Search Method: 1. Probe 2. Probe Proxy 3. Network Directory PACKET EXCHANGE PROTOCOL (PXP) CONFIGURATION: Checksum Enabled: N Retransmission Interval (Secs): 10 Maximum Retransmissions Per Request: 4 TRANSMISSION CONTROL PROTOCOL (TCP) CONFIGURATION: Checksum Enabled: N Maximum Number of Connections: 256 Retransmission Interval Lower Bound (Secs): 4 Maximum Time to Wait For Remote Response (Secs): 180 Initial Retransmission Interval: 5 Maximum Number of Retransmissions: 4 Connection Assurance Interval: 600 Maximum Connection Assurance Retransmissions: 4 CONFIGURED NETWORK INTERFACES: Network Interface Type: LAN Network Interface Name: LAN1 Network Interface IP Address: A xxx.xxx.xxx.xxx IP Subnet Mask: 255.255.248.000 Network Segment Size: 1514 HP UPC Number: 08-00-09 Number of Outbound Buffers 128 Enable Ethernet: Y Enable IEEE802.3: Y Number of Store and Forward Buffers: 20 Load Network Directory Mappings: No . .. .. Regards Richard Bayly Hewlett-Packard Response Centre, Australia "Steve Hammond" <[log in to unmask]> wrote in message news:9jkgne01ame@enews2.newsguy.com... > I have been asked to determine the configuration of my NIC card on my 987 - can anyone give me a hint? > > thx > steve > > * To join/leave the list, search archives, change list settings, * > * etc., please visit http://raven.utc.edu/archives/hp3000-l.html * > * To join/leave the list, search archives, change list settings, * * etc., please visit http://raven.utc.edu/archives/hp3000-l.html *