Hi Donald,

When we used DOS Reflection on our DTCs, there was a configuration on the DTC that we needed to set to tell it to auto-sense the baud rate.  I wasn't in on doing the actual configuration, so I can't tell you where in the DTC manager software to look.

Also, to get auto-sense to work correctly, we had to be logged out of the DTC before changing baud rates in Reflection.  Kind of like this:

DTC >
l     <<< that's a lower-case 'L'  it stands for 'Logoff'
disconnecting.....
(change baud rate in Reflection here.  Don't press Return until you've changed the baud rate.)
<return>
<return>
DTC >

That we got the DTC prompt back let us know that the DTC recognized our baud rate changes.

Regards.

Donald Frantum wrote:

> Are there any restrictions for Reflections for DOS when using a DTC.  I am currently trying to raise the Baud Rate from 9600 to 19200 on a HP Vectra 386.  However when I raise the Baud Rate, I get junk characters.  Does anyone have any insight into what I might be doing incorrectly or if there are just limitations that I am not aware of.
>
> TIA
>
> Donald N. Frantum
> IS Manager
> California Style, Inc.
> (760) 918-3704
> [log in to unmask]

--
----------------------------------------------------------------------
  John MacLerran
  IT Systems Analyst                       email:   [log in to unmask]
  Idaho State University                             V(208) 282-2954
  http://www.isu.edu/~macljohn                       F(208) 282-3673
----------------------------------------------------------------------