Pandey, This sounds very serious. If you have a contract I would suggest call HP and let them look at it. In the 3 years I worked with HPe3000's I have never seen nor heard about this problem. Regards, Jan Gerrit Kootstra "Pandey, Pushkar TCS1C" wrote: > > Gents, > > We replaced a CPU card on 918. This was pre-configured for HP-UX. We changed > it to MPE through ss-config and did a fresh installation on the system (SLT > tape of MPE/iX 5.5) > > The H/W config is : > > Disk : 56/52.6.0 > DDS Tape Drive : 56/52.0.0 > CD-ROM Drive : 56/52.2.0 > > The installation was successful from SLT, but after rebooting the LDEVs > configured were only LDEV 1 and LDEV 20. > I could not get LDEV 7 and LDEV 6, even though they appear in sysgen (lp and > ld commands). > > While booting I get the error message " Higher level component not > configured" > > Also we get "Pascal error -650" when system comes up. > > I can logon as manager.sys, but can not get LDEV 6 and LDEV 7 and LDEV 10 > going > > Please share your valid and useful experiences on this problem. > > Thanks & regards > > Pushkar Pandey > System Engineer