Ok guys. I've read the manual on installing the UPS monitor
and I have found the little bit in the annex that says how to set
up the port for the UPS monitor but I can't seem to follow the
instructions.  Either that, or I am following them and it simply
doesn't work.

My system's IOMAP shows this:

Bus Converter(56)
   Device Adapter(56/52) --- A1703-60003-SCSI SCSI
      Device Adapter(56/52.0) --- PSEUDO
         Device(56/52.0.0) [ ldev 7 HPC1533A TAPE]
      Device Adapter(56/52.2) --- PSEUDO  ***NOT PRESENT***
      Device Adapter(56/52.3) --- PSEUDO  ***NOT PRESENT***
      Device Adapter(56/52.4) --- PSEUDO  ***NOT PRESENT***
      Device Adapter(56/52.5) --- PSEUDO
         Device(56/52.5.0) [ ldev 2 ST15150N DISK]
      Device Adapter(56/52.6) --- PSEUDO
         Device(56/52.6.0) [ ldev 1 ST15150N DISK]
      Device Adapter(56/52.8) --- PSEUDO  ***NOT PRESENT***
         Device(56/52.8.0) [ ldev 6 HP2567B LINE PRINTER ***NOT PRESENT***]
      Device Adapter(56/52.9) --- PSEUDO  ***NOT PRESENT***
         Device(56/52.9.0) [ ldev 10 HPC1503B TAPE ***NOT PRESENT***]
   Local Area Network(56/56) A1703-60003-CONSOLE/LAN CONSOLE/LAN ->

The manual says that based on the LAN/CONSOLE multio
card being at address 56/56 then the UPS port should be
configured as 56/56.3 which is what I did.  However on a
restart with norecovery the following pops up at me.

LDEV 22 LLIO device configuration error -1 status -subsys
#150 info # -11

followed a little later by

Ldev 22 not added LLIO device configuration error -11


Now as far as I can tell, I have followed the instructions
exactly as written.  Can anyone tell me exactly what these
errors mean and where I should look to resolve them?

Trusting in a speedy and accurate response, I remain,


  Your ever indebted servant,
                Jim
---
James B. Byrne                Harte & Lyne Limited
vox: +1 905 561 1241          9 Brockley Drive
fax: +1 905 561 0757          Hamilton, Ontario
mailto:[log in to unmask]  Canada L8E 3C3