Subject: | |
From: | |
Reply To: | |
Date: | Wed, 5 May 1999 11:05:30 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Try adding to the npconfig file the following command
pjl_supported=FALSE
Kim Borgman wrote:
>
> OK gurus, I get the following errors every 60 seconds on my console. The
> laser printer on the network (5siMX) keeps printing the header page
> over/over. Happens once every week or so. I have to stop the spooler, turn
> off the printer, defer the spoolfile, and then start it up again. When I
> called HP the last time I was told to put a command (i forget it
> exactly-something=false) in the npconfig file. It fixed the problem but
> caused others that were worse, so I had to back it out. Attached is also my
> NPCONFIG layout.
>
> TIA....................
>
> ERROR:
>
> 8:53/209/Output spooler, LDEV #172; The IPCRECV intrinsic reported error 64
> while waiting for a generic event completion. The error text is: REMOTE
> ABORTED THE CONNECTION. (SOCKERR 64) Native Mode Spooler message 9646.
>
> 8:54/209/Output spooler, Ldev #172: Device has reported a power failure or
> other interruption while outputting the header for SPOOLID #O21660. The
> spooler will reprint the header. Native Mode Spooler message 9029.
>
> NPCONFIG layout:
>
> global (setup_file = pcllp.hpenv.sys
> MESSAGE_INTERVAL = 300
> banner_intray = 1
> banner_trailer = false
> data_timeout = 15
> jam-recovery = false)
> 172 (network_address = iiljw2.nws.com
> setup_file = pcllp.hpenv.sys)
>
> Kim Borgman, MIS
> NWS, Inc.
> 317-917-1399
> [log in to unmask] <mailto:[log in to unmask]>
|
|
|