> help digipage
> USER DEFINED COMMAND FILE:  DIGIPAGE.CMDFILE.SYS
>
> parm pagernum=" ", code=" ",DELAY=7,P1=" "
> COMMENT &1 NEED TO PAGE SOMEONE
> file dpconfig=digipage.data.sys
> run digipage.UTIL.SYS;info="!pagernum !delay !code"
> reset dpconfig
> setvar paged true
>
>
>   FILE digipage.data, Recsize = -72 Eof = 5
> 960          << baud >>
> 2101         << ldev >>
> ATV0E0L3S0=0S7=1        <<modem setup >>
> ATDT9,                  <<modem dial prefix >>
> 3                       << ignored in this version >>
>                         << remove these >>
>
> ******************
>    DigiPage - Access a Hayes SmartModem from a modem port and use
>                  AT commands to dial pager and display a code.
>
> ----------------------------------------------------------------------
> ---
>    Usage:
>             RUN DIGIPAGE;INFO="pager_number delay_factor display_code"
>       Or:   RUN DIGIPAGE;INFO="filename"
>
> ----------------------------------------------------------------------
> ---
>     Parameters:
>       pager_number = 12 ASCII characters (0-9) indicating the
>                      access number of the pager to be called.
>       delay_factor = Integer (1-9) indicating the amount of time to
>                      pause before sending the display code to the
> pager.
>       display_code = 10 ASCII characters (0-9) indicating the
>                      code to be displayed on the pager.
>       Note: The above info string parameters must be seperated by
> spaces.
>
>
>       filename     = Fully qualified name of 72 byte ASCII file
> containing
>                      1 DigiPage info string per record.
>
> ----------------------------------------------------------------------
> ---
>    Function:
>       DigiPage opens a modem/terminal ldev and puts it in a mode that
> will
>       allow strings of ACSII characters to be sent out the port and
> accepted
>       by a Hayes compatable modem. Once this is done a command is sent
> to the
>       modem that disables the character echo during command mode and
> changes
>       the command result codes to numeric (followed by a CR). The
> FREAD read
>       trigger for the modem port is changed to a CR thus allowing
> DigiPage to
>       send commands and receive the result code. This protocol is used
> to
>       program the modem to call the pager phone number specified,
> pause a few
>       seconds, then continue dialing with the display code specified.
> This
>       continuation of the modem dial command is picked up by the pager
>       service (if the delay factor is correct) as if someone had
> manually
>       entered the code to display.
>
> ----------------------------------------------------------------------
> ---
> ----------
> From:         ROGER SMITH[SMTP:[log in to unmask]]
> Sent:         Monday, June 22, 1998 5:17 AM
> Subject:      Help with DIGIPAGE
>
> I am trying to get Digipage working on our HP3000.  When I run it, I
> get
> a END OF FILE  (FSERR 0) and a **** PROCESS QUIT; PARAM = -26 message.
>
> All helpful hints are appreciated.
>
> Roger                           [log in to unmask]
>
>