Okay, as I posted a couple of days ago, we are converting our 2563B 
and LM615 printers from HPIB to serial.  The conversion was okay, but 
I have two problems:

1)  I can't seem to change the baud rate on the LM615 from 300.  I have 
tried config options from 20 to 29 and various values for those options, 
but the baud rate doesn't change, ever.  Any ideas?

2)  The 2563B printer won't print (well, actually it prints gobbledy-gook).
It attempts to print but the spooler drops with this error message:

STARTSPOOL 205
20:47/61/Output spooler, LDEV #205:  Started.
:20:47/61/Output spooler, LDEV #205:  The spooler could not complete
output of file O458.OUT.HPSPOOL.
Native Mode Spooler message 9511

20:47/61/Output spooler, LDEV #205:  The file system reported a device
error
while outputting data.
Native Mode Spooler message 9540

20:47/61/Output spooler, LDEV #205:  FDEVICECONTROL error.
Native Mode Spooler message 9547

20:47/61/Storage Management SIO undefined function.
(FILE SYSTEM ERROR -6001)
File System message 6001

20:47/61/Printer storage manager; an error was reported from a lower level
subsy
stem.
Printer Storage Manager message 13

20:47/61/A DATA TRANSMISSION error occurred.
Low Level I/O message 207

20:47/61/Printer storage manager; device is off-line.
Printer Storage Manager message 23

20:47/61/The device is off-line.
Low Level I/O message 204


Here's the Profile for the printer(s):

NMMGR/3000 (B.06.00) #21 Printer Profile                               
Data: Y 
Fill in the required information; then press the Save Data key.            
    
Command:                                                                   
    
PATH:  DTS.PROFILE.P122D96                                                 
    

Printer type      [22]  (18, 21, 22, or 26)                        
   or printer type file name [                          ] 

Line speed        [300  ]  (300, 1200, 2400, 4800, 9600, 19200, or 38400
bps)   
Record width       [132 ]  (1... 2048 bytes)
Modem type            [0]  (0 - none, 1 - US, 2 - European)
Modem behavior        [0]  (0 - none, 1 - DCE, 2 - DTE, 3 - DCE high)
Parity             [NONE]  (None, Even, Odd, 0's, or 1's)
Initially spooled?    [Y]  (Y/N) 
NLIO device?          [N]  (Y/N)
Hardware handshaking? [N]  (Y/N)

If configuring device classes, enter names below.  If additional names are
required, press Go To CLASSES, otherwise press Prior Screen.

   Device class   [LP      ]  [        ]  [        ]  [        ] 
      names       [        ]  [        ]  [        ]  [        ] 

File:  NMCONFIG.PUB.SYS                      

Any ideas are appreciated.  I've been at this for 9 hours solid and I'm
going home.

Jim Phillips                            Manager of Information Systems
E-Mail: [log in to unmask]      Therm-O-Link, Inc.
Phone: (330) 527-2124                   P. O. Box 285
  Fax: (330) 527-2123                   Garrettsville, Ohio  44231