Bob:

It has been a while since I configured one on a 9X7 but here
is a path from a 928 for the HPIB interface card. I believe that
the configurations are the same except for the path #.

Hope this helps.

Gary

PATH:  56/40                                  LDEV:
  ID:  HPA1700-60001                          TYPE: CA
PMGR:  SPECTRUM_CIO_CAM                    PMGRPRI:     6
LMGR:                                       MAXIOS:     0

PATH:  56/40.0                                LDEV:
  ID:  HP27113A                               TYPE: DA
PMGR:  HPIB_DAM                            PMGRPRI:     6
LMGR:                                       MAXIOS:     0

PATH:  56/40.0.0                              LDEV:   11
  ID:  HP7937XP                               TYPE: DISC
PMGR:  CS80_DISC_DM                        PMGRPRI:     8
LMGR:  LOGICAL_DEVICE_MANAGER               MAXIOS:     0

PATH:  56/40.0.1                              LDEV:   12
  ID:  HP7937H                                TYPE: DISC
PMGR:  CS80_DISC_DM                        PMGRPRI:     8
LMGR:  LOGICAL_DEVICE_MANAGER               MAXIOS:     0

At 05:54 PM 7/13/97 U, bob mcgregor wrote:
>We purchased a series 937 to replace our 932 and were told we could use
the HP-IB cards from the 932 in the 937.  My question is what DA do I
specify in Sysgen so the system will recognize the configuration?  I am
getting an LLIO error during boot and I'm sure it's because I'm specifying
the wrong ID for the card.
>
>TIA, bob
>
Gary L. Biggs, N5TTO
[log in to unmask]
Interex SIG Allbase Chair

"Abandon all hope, Ye who Inter(net) here" --
Dante, over the portal(router) to Hell