On Thursday, June 26, 1997 11:11 AM, Gregory R Olen
[SMTP:[log in to unmask]] wrote:
>
> To accomodate this move I would like to rearrange this setup to
look
> like
>
> DTC -- HP3000 -- Ethernet Hub -- DTC -- Ethernet Hub
>
> or
>
> DTC -- HP3000 -- Ethernet Hub -- Ethernet Hub -- DTC.
>
>
> So will I be able to simply disconnect the DTC and plug it back in
> at a
> different location without any problems ???

As long as it's on the same segment of coax, or if using a router,
"bridging" is turned on (unless it's a 16MX or 72MX, in which case.
the IP address is in the routing table.) - you should not have
problems.  I've used DTC's over a 56K Frame Relay Link, clear across
the country without a problem.  And yes, printers run off them...
>
> On a secondary issue - can I hook up Laserjets on the Ethernet
> network up
> to the HP3000 with MPE 5.0 or do I need 5.5 ??

To use Network Printing from MPE, you need 5.5.  There are third
parties which have products which operate under 5.0 and before.

Cheers,
Joe

---------------------------------------------------------------------
Joe Geiser
CSI Business Solutions
140 Bristol-Oxford Valley Road
Suite 102
Langhorne, PA 19047-3083, USA
Phone: +1 (215) 945-8100/Fax: +1 (215) 943-8408
E-Mail:  [log in to unmask]    WWW: http://www.csillc.com
---------------------------------------------------------------------