A.K.Mani <[log in to unmask]> a icrit dans l'article
<[log in to unmask]>...
...
>       I have connected dot matrix printer under DTc using profile
PR22D24.
> It is working fine. Similarly I did configure Troy and IIID laser
printers
> using the profile PR22D96. For this, 2 dev classes have been assigned.
> Assigned Ldevs 201 and 202 respectively and validated successfully.
>
> After issuing print command, the following msgs appears on the screen.
>
> 13:43/152/Output spooler, LDEV #201 : The spooler could not complete
outout o
> FILE O1100.out.hpspool
> Native Mode Spooler message 9511
>
> 13:43/152/Output spooler, LDEV #201: The file system reported a device
error
> during header processing.
> Native Mode Spooler message 9539
>
> 13:43/152/Output spooler, LDEV #201: FDEVICECONTROL error
>
> 13:43/152/Printer Storage manager;device is off-line
> printer storage manager message 23
>
> 13:43/152/The device is off-line
> Low level I/O message 204
>
> 13:43/152/Output spooler, LDEV #201: stopped
>
You can't use Terminal type 22 for non-HP printers.  Termtype 22 or 26 are
doing some "status request" and non-HP printers can't answer to those.
Even most recent HP printers (Like Laserjet 4 and later models) do NOT
answer to status request.  I'm 100% sure that Laserjet, Laserjet + and
Laserjet II answer.  Laserjet IIP do not.  I'm not sure about Laserjet
IIID.  To use these printers on a HP3000, you need to use a terminal type
18 profile.

Hope it helps.

Denis St-Amand ([log in to unmask])
Info Panama Service
Beauport (Quebec), Canada
--------------------------------------------------------------
If you look at the stars at night, and you see one moving much
faster than all the others, You know who is driving it !!!
                     Remember Ayrton Senna da Silva, 1960-1994
--------------------------------------------------------------