We do a couple of DTC still connected,,,,,

The pauses have been around for a while, but seem to be getting worse.

What I need is a way to find the broadcast msgs and see if there is a pattern in their source...


Please consider the environment before printing this e-mail.

-----Original Message-----
From: Mark Ranft [mailto:[log in to unmask]]
Sent: Tuesday, 15 December 2009 9:10 AM
To: John Pitman
Cc: [log in to unmask]
Subject: RE: [HP3000-L] network pauses

Don't forget to check that both the LINK (in NMMGR) and the switch are set
to 100-BT and FULL duplex.  And since you are seeing broadcast packets, that
might indicate that you are connected to a hub.  Otherwise the thing doing
the broadcast would have to be something on the same VLAN.  Broadcasts could
be a non-TCP/IP device like a DTC or a misbehaving device (like a network
card/cable going bad on a device that usually would work.)

Are the pauses something new?

Mark Ranft
Pro 3K




CAUTION: This message may contain privileged and confidential information intended only for the use of the addressee named above. If you are not the intended recipient of this message you are hereby notified that any use, dissemination, distribution or reproduction of this message is prohibited. If you have received this message in error please notify RYCO Hydraulics Pty. Ltd. immediately. Any views expressed in this message are those of the individual sender and may not necessarily reflect the views of RYCO Hydraulics Pty. Ltd.

* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *