Do you have a PSEUDO device configured at 56/52.5? What is the state as
reported by DSTAT ALL? Did you use VOLUTIL to assign it to a volume set?

***************************************************************
 CDR Paul Edwards USNR Ret.       HP 3000/9000 Certified Consultant
 Paul Edwards & Associates        Phone: (972) 242-6660
 1506 Estates Way                 Fax  : (972) 446-9022
 Carrollton TX 75006              Cel  : (214) 384-8728
 Email: [log in to unmask]          Web  : www.peassoc.com
***************************************************************

-----Original Message-----
From: HP-3000 Systems Discussion [mailto:[log in to unmask]]On
Behalf Of John P. Bardessono
Sent: Friday, October 17, 2003 4:21 PM
To: [log in to unmask]
Subject: Re: Ldev 2 won't avr at boot


Just install an HP disk, ST39216N, and set it up as ldev 2.  Works find
except it won't AVR at bootup.

It is visable durring the ipl process, I can do a SEARCH and it is listed
with ldev 1 and the tape drive.

Its an HP 9gb disk configured with ID=ST39216N, SCSI ID is set to 5 and the
path is 56/52.5.0.  Am booting with mpeix/7.0 from install tape thru fos and
subsys/prod tapes.  I can mount it with the utilities AVRSCIS.INSTALL.SYS
"mount 2" and then it works fine until a re-boot.

Any ideas?

* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *

* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *