Our building is being rewired starting this week to replace a mixture of
Cat3 and Cat5 wiring with all new Cat5 and new switches.
My 928 is connected to the network with a Thicklan coax BNC attached to the
AUI port of a Cisco switch. In the same line is a DTC/48. I still have 3
serial devices that need to be attached to the 3000. I want to get rid of
the Thinklan coax.
I have read on the IRC on how to switch over the 928 card, by moving some
jumpers, from Thicklan to the RJ45 connection. Sounds rather
straightforward. (have not attempted it yet though)
How do I go about changing the DTC/48 over to use the RJ45 connection?
What I have done so far is - Remove the network card and move the block of
six jumpers over to the AUI side. Now what do I do? How do I communicate
with the DTC to assign it a IP address?
TIA
* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *