The problem isn't with adding a drive to the system volume set, it's with
losing the system volume set information that was stored on LDEV 2 before it
went bad.  Unfortunately, you'll have to rebuild your system volume set
using either the factory SLT/FOS/Subsys/etc or your custom SLT (CSLT)
created in Sysgen.  Then you can restore your data and be back at square
one.
___
Tony Newton



-----Original Message-----
From: Gibson Nichols [mailto:[log in to unmask]]
Sent: Wednesday, June 05, 2002 6:47 AM
To: [log in to unmask]
Subject: [HP3000-L] Need SLT tape to add disk to system volume set?


Had LDEV 2 problem.  HP replaced the drive.  Now they say we need a SLT tape
to add the drive to the system volume set.  Do we?  If we are willing to
lose all
the data and do a complete reload then can't we just create a new SLT tape?

Isn't there a method to add a drive to the system volume set without an SLT
tape?

* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *

This message is intended for the sole use of the individual and entity to
whom it is addressed, and may contain information that is privileged,
confidential and exempt from disclosure under applicable law.  If you are
not the intended addressee, nor authorized to receive for the intended
addressee, you are hereby notified that you may not use, copy, disclose or
distribute to anyone the message or any information contained in the
message.  If you have received this message in error, please immediately
advise the sender by reply email and delete the message.  Thank you very
much.

* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *