If I recall correctly, the DTC48 has to be physically switched from BNC to
AUI. It does not auto-sense like the newer models. Unfortunately, I do not
recall "where" the "switch" is. This was an operation usually performed by
the HP CE when I had the setting changed.

Regards,


Rocky J. Costantino
Vice President - Operations, Professional Services
Computer Design & Integration, LLC
696 Route 46 West, Teterboro, NJ 07608
Phone: 201-931-1420 x224
Fax:     201-931-0101
[log in to unmask]
www.cdillc.com



-----Original Message-----
From: Beghein Johan [mailto:[log in to unmask]]
Sent: Saturday, April 20, 2002 10:17 AM
Subject: DTC 48 Interface


Hello,

I'm trying to replace a few BNC connections by RJ45.

I have an old DTC48, I took the coax link off, put a external AUI to RJ45
tranceiver from Centrecom on the AUI interface of the DTC, connected the
tranceiver to a hub  and reboot the DTC.

The DTC can't download its config.

Does anybody tried the same ?
Is there something to change on the DTC side, or are all the interfaces up ?
Do i need a specific tranceiver ?

I know my hub can connect with the coax segment, because my HP3000 is on the
hub, and my DTC's are on the coax, and everything works fine.

Thanks everybody.

Regards,

Beghein Johan
[log in to unmask]

* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *