Have you configured more than 1 lun ?

If you have not, you would expect to see exactly what you are seeing - 1
lun with a max. of 4gb that can be seen by mpe.

To configure a maximum of 8 luns, you need to do this from the front panel.

After you have done an install onto the primary path, you should be able to
run ODE mapper just prior to the start norecovery phase of the install.

ODE mapper should actually show duplicate paths for each lun. That is how
it works.

Of course, you will only need to configure 1 path for each lun which will
correspond to 1 ldev. number. All ldev's should be configured to correspond
to the first set of paths shown by ODE mapper.


At 07:11 PM 2002-03-28, Bill McChesney wrote:
>Has anybody have this working on 9x7 system that can tell me why i keep
>getting dupicate drives. Every lun is a duplicate of lun 0 and prevents
>me from using more than 4 gb and i have 45gb installed. I have the
>lastest firmware on the f/w controller and the disk array controller
>firmware is at HP62. Im installing mpe 6.5 and from what i see requires
>no special patches. Im only using one controller(x) and one f/w
>controller. ODE id's everything 100% and all diags run on the 12H-no
>errors. Any help would be appreciated.
>
>Thanks
>Bill
>
>* To join/leave the list, search archives, change list settings, *
>* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *

-------------------------------------------------------------------------------------------------
Gilles Schipper
GSA Inc.
HP System Administration Specialists
300 John Street, Box 87651   Thornhill, ON Canada L3T 7R4
Voice: 905.889.3000     Fax: 905.889.3001
email:  [log in to unmask]  web: http://www.gsainc.com
-------------------------------------------------------------------------------------------------

* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *