If you want the paper to come from a specific tray regardless of
the type of paper in it, use the PCL Paper Source command in your
setup file. For our HP4000's the command is ESC&l#H then 1=tray2,
4=tray1, 5=tray3 and 8=tray4.
Hope this helps
*******************************************************
Sam Knight Phone (904)745-7509
Sr. Programmer/Analyst Fax (904)745-7238
Jacksonville University
Jacksonville, FL 32211
-----Original Message-----
From: Gary Jackson [mailto:[log in to unmask]]
Sent: Thursday, October 18, 2001 3:20 PM
To: [log in to unmask]
Subject: Network printing, NPCONFIG, & data_intray
Oh learned ones-
After scouring the archives of HP3000-L I am still confused. I have an HP
8xxx LaserJet with a 2000 sheet bin. I configured NPCONFIG with
data_intray=4. After doing a STARTSPOOL, the printer demanded that I load
paper in tray 2. Trays 2 and 3 had been pulled out to try and force a tray
4 selection. I could not find a way to get it to take paper from tray 4
UNTIL I looked at the LaserJet configuration for tray 4 and found that it
had been defined as "pre-punched", since that is what was in it. I changed
it to "plain" and then the spooler would take paper from tray 4. Does
network printing require that the paper come from bins marked "plain"? How
do it know?
Gary Jackson
QSS
* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *
* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *
* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *
|
