On 21 Jun 2001, at 11:05, Stan Sieler wrote:

> If you have a C1503 tape drive, and if you have a 6.0 or earlier
> release of MPE/iX on the disk, you can boot to MPE, and do:
>    :sysdiag
>    run scsidds; section=50
> and then enter some command to get the firmware revision...but I
> forget what it is.  I do recall seeing more than one obvious
> command, and that the firmware revision was buried way down
> somewhere :)
>

I don't have HP HDWR support so I don't have access to this
particular diagnostic (password protected).  I did run sysmap
however and discovered that the device configured for the tape
drive is HPC1533A but that sysmap says it should be a
HPC1537A.

Regards,
Jim



---   *** e-mail is not a secure channel ***
James B. Byrne                Harte & Lyne Limited
vox: +1 905 561 1241          9 Brockley Drive
fax: +1 905 561 0757          Hamilton, Ontario
mailto:[log in to unmask]  Canada L8E 3C3

* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *