On Mon, 18 Jun 2001 11:19:26 +1000, "Richard Bayly"
<[log in to unmask]> wrote:
>Bob, the HPTCPJD is an id for network printers. Only HP Printers that
>support PCL are supported under MPE/iX. However, non-HP printers should work
>ok. The other parameters in the sysgen listing will determine if the printer
I'm attempting the same. In my case it's a barcode label printer with
no PCL support, attached to a jetdirect box. However, unless I'm doing
somethring wrong, you cannot convince OUTSPTJ (?) to not include some
PJL and PCL initialization and termination strings. It will always
start with <Esc>%-12345X (PJL I believe), followed with some PCL code
to reset the printer.
>is a network printer or not, and if it is it will use the correct spooler,
>OUTSPOOL, or OUTSPTJ (for network printers). When it determines it is a
>network printer it will look in npconfig.pub.sys for the IP address for the
>given device number, along with any other settings.
>
>The likely problem is that the printer is not talking via a HP Jetdirect
>card. The spooler will be expecting certain SNMP replies from the card, and
>will fail if it doesn't get them. However you may be able to get around it
>by specifying:
>
>PJL_SUPPORTED=FALSE and
>SNMP_ENABLED=FALSE
>
>in npconfig. So trying adding these entries, and then restart the spooler on
>that device.
>
Done this, doesn't do the whole job.
Are there perhaps other (undocumented) settings to force "raw" mode,
i.e. just sending the raw data to the printer?
>Regards
>
>Richard
>
>______________________________________________-
>Richard Bayly
>Hewlett-Packard Response Centre, Australia
>
>
>
>
>"Bob Stewart" <[log in to unmask]> wrote in message
>news:9g07i508oq@enews3.newsguy.com...
>> I am trying to configure a Brother 1270N on an HP 3000 running MPE/ix ver.
>> 5.5 and am having no success. I believe the problem may be the id=HPTCPJD
>> line in the sysgen. Since this is not an HP printer I believe the id needs
>> to be something else, but don't know what. Any help is appreciated. TIA
>>
>>
>
>
If you find a solution, short of using a third party package, please
let us know.
regards,
Danny A. van Delft [log in to unmask]
* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *
|