Thus it was written in the epistle of Mark Undrill,
>
> It's been a while but as far as I recall, to enable Auto Reply you have to
> go into SYSGEN, select io and then "adev ldev#;mode=AUTOREPLY" where ldev#
> is the logical device number of your backup device (normally 7). Then exit
> back to the sysgen> prompt, type keep to save your new configuration and
> then exit.
>
> Now you will have to re-boot your e3000 for the changes to take effect.

Alternatively, you can run any of a number of programs which will allow
autoreply to be turned on and off.  I have Pascal source code for such a
program if it would be of help (and I be could be talked out of a compiled
version :-).

Ted
--
Ted Ashton ([log in to unmask]), Info Sys, Southern Adventist University
          ==========================================================
When writing about transcendental issues, be transcendentally clear.
                                        -- Descartes, Rene (1596-1650)
          ==========================================================
         Deep thoughts to be found at http://www.southern.edu/~ashted

* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *