If you know how to get to the "registers" (I don't know if HP calls them that)
you will need to change #22  to whatever value is configured for the baud rate
you desire. If you contact me off-list I have a partial listing of some of the
registers I can fax to you. Only 9600 baud is mentioned on this sheet for #22,
however, I know you can set this at a lower speed.

>>> Ted Ashton <[log in to unmask]> 02/27 1:09 AM >>>
Could someone advise me on how to set the baud rate and so forth on a 2564B
line printer?

Thanks,
Ted
--
Ted Ashton ([log in to unmask]), Info Sys, Southern Adventist University
          ==========================================================
Young Men should prove theorems, old men should write books.
                        -- Hardy, Godfrey H. (1877 - 1947)
          ==========================================================
         Deep thoughts to be found at http://www.southern.edu/~ashted