Subject: | |
From: | |
Reply To: | |
Date: | Sat, 22 Jul 2000 05:15:48 -0600 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Pandey,
This sounds very serious. If you have a contract I would suggest call HP
and let them look at it.
In the 3 years I worked with HPe3000's I have never seen nor heard about
this problem.
Regards,
Jan Gerrit Kootstra
"Pandey, Pushkar TCS1C" wrote:
>
> Gents,
>
> We replaced a CPU card on 918. This was pre-configured for HP-UX. We changed
> it to MPE through ss-config and did a fresh installation on the system (SLT
> tape of MPE/iX 5.5)
>
> The H/W config is :
>
> Disk : 56/52.6.0
> DDS Tape Drive : 56/52.0.0
> CD-ROM Drive : 56/52.2.0
>
> The installation was successful from SLT, but after rebooting the LDEVs
> configured were only LDEV 1 and LDEV 20.
> I could not get LDEV 7 and LDEV 6, even though they appear in sysgen (lp and
> ld commands).
>
> While booting I get the error message " Higher level component not
> configured"
>
> Also we get "Pascal error -650" when system comes up.
>
> I can logon as manager.sys, but can not get LDEV 6 and LDEV 7 and LDEV 10
> going
>
> Please share your valid and useful experiences on this problem.
>
> Thanks & regards
>
> Pushkar Pandey
> System Engineer
|
|
|