Take a look at NPCONFIG.PUB.SYS and see if you have a global or local
setup file defined. You probably need to define and empty setup-file to
prevent any setup from being sent. If there is no setup file defined,
then MPE sends a default setup. You can also use a FILE ;ENV=  to
override any setup files. See the Native Mode Spooler Reference Manual
at

http://docs.hp.com:80/dynaweb/smpe/b1020/fix071/@Generic__BookView

Chapter 3  Configuring and Operation Network Printers
  See the section Creating and Using Setup Files


Anyone out there actually been here, done that already?


Carro Arrubarrena Mariano wrote:
>
> I have a Printronix Dot matrix printer on the Network wit an IP address.
> It is supposed that I can set it up on the network, but this printer does
> not support PCL,
> I'm using it to print pre printed forms, but it is printing some characters
> at the beginning of the page,
> And it changes  the alignment.
> Some of you guys know how can I disable the pcl, and use it to send raw text
> without any escape control sequences?
>
>     Mariano Carro
> ????   E-mail: [log in to unmask]
> ?????Phone: (972) 855-1120
> ????      Fax:    (972) 855-1110 / 702-0994