Has anybody tried to use the telnet client on the HP e3000 to connect to a
Cisco router?  I'm working on an A500 (MPE/iX 7.0) and when I telnet to the
Cisco router I get a series of error/warning messages and then a failure
(see below - IP address has been removed).  While watching it on a "sniffer"
it would appear to close the connection when the router tries to send some
configuration information back.  It works perfectly well from a PC.  I'm
wondering if there is a setting or toggle I need to set prior to "opening"
the session.

[1]/TECHGRP/BACKUJ>telnet x.x.x.x
Telnet Client [A7000000]     (C) Hewlett-Packard Co. 1994
Trying...
Connected to x.x.x.x.
Escape character is '^]'.
Failed to turn on single echo: 68.
Failed to turn on single echo: 68.
IPCSend failed: result = 67.
Send to 10.5.1.3 failed.
Failed to enable Transparent: result = 72.
Failed to turn on typeahead: -255.
Failed to turn on single echo: -255.
Failed to turn on echo: -255.
Failed to disable Transparent: result = 72.
Failed to turn on echo: -255.
Failed to enable Transparent: result = 72.
Failed to turn on typeahead: -255.
Failed to turn on single echo: -255.
Failed to turn on echo: -255.
Failed to disable Transparent: result = 72.
Failed to turn on echo: -255.
Connection closed by foreign host.

Thanx,
  Jonathan (Jon) M. Backus, MPE-CSM ~ President
  Tech Group ~ 15 Catawba Place ~ Hagerstown, MD ~ 21742-6515
  Email: [log in to unmask] ~ AIM: JMBackus
  Vmail: 301.988.0614 ~ Fmail: 301.714.1854
  Web: www.TechGroupMD.com