Use the Reflection setting "Allow Exit While Connected"  to control logoff
behavior.  By default users are allowed to terminate a Reflection session
without logging off.   Uncheck this setting to disallow termination without
logging off.

This setting is accessed in the Connection Setup/More Settings dialog.

Joe Silagi
WRQ, Inc.


"Gibson Nichols" <[log in to unmask]> wrote in message
news:b2j9tn$drl1@eccws12.dearborn.ford.com...
> ** NS/3000 NETIPC ERROR IN VT; JOB:0; PIN:65; INFO:1-ERROR 42;
>
> I think this error message is caused when the user's PC will not respond
to
> the HP 3000 system.  Perhaps this can occur when the user disconnects by
> clicking on the "X" in the upper-right hand corner of the Reflection
> terminal emulator.  The solution would be to educate all the customers to
> logoff of the system properly before disconnecting.  We suggest that the
> message be ignored because we have little hope that all of the customers
> would comply with this  request.  It becomes a continuous effort to inform
> the customers of the requirement.  The error causes no other known problem
> so the risk is lower than the cost to handle it.
>
> But is there a way to eliminate the message?  Can we filter messages going
> to the console?
>
>

* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *