Hello all,

I was wondering if anyone on this list has been exposed to this - which
looks like a bug in the Dynamic Detail eXpansion facility:

Suddenly, the application goes down with an error, indicating that the
detail set is full.

This detail set is enabled for DDX.

If you run DBUtil, issuing a SHOW <base> CAPACITY, this nasty little message
shows up:


                   No. of    %Max --------------- Capacity ----------------
Dyn
Data Set Name Type Entries    Cap Maximum    Current    Initial   Increment
Exp
                                                       (Hashing)
:
<setname>        D 235268     13  1800000    252000     180000    18000
YES
  Dynamic capacity expansion in progress flag is on.
:

Normally we grab DBGeneral  - and change the capacity and the error is gone.
Since this involves a backup of the base first - this is not very popular
with the users ;-)

HP Support have been working on the case for some time; but no
solutions/explanations so far...

MPE/iX is 5.5 and the TurboIMAGE Overall VUF is: HP30391C.07.14
TurboIMAGE/XL


TIA - and with kind regards,

/Hans

====================================================================
Hans-Ole Kaae                       Vox: (+45) 87 34 55 07
IT-Consultant                       Fax: (+45) 87 34 55 66
ScanConsult·IT-Partners ApS         Mob: (+45) 40 42 55 07
Udviklingsparken Aarhus             E-mail: [log in to unmask]
Soenderhoej 14
DK-8260  Viby J.
Denmark                             web: http://www.scanconsult.dk