Look at printer default number of copies.  It may be set to two (2)...

--
=========================================
Denis  (Remove "removeit." from email address)
=========================================
"Hans-Ole Kaae, ScanConsult" <[log in to unmask]> wrote in message
news:IYycnRS4s6zfxkKjXTWcog@fidnet.com...
> Hello gentle Listers,
>
> We have a problem on a 'remote 3000' (MPE/iX 6.5) that I haven't been
> able to solve so far.
>
> The 4Si is equipped with a JD-card and print is routed from the 3000
> via NPCONFIG:
>
> <snip>
>
> nnnn   (Network_Address = {Here is a valid ip-address}
>         Setup_file = NULL.HPENV.SYS
>         Pjl_Supported = FALSE
>         Jam_Recovery =  FALSE)
> #       {Here is a comment re. the placement of the printer}
>
> <snip>
>
> Ordering prints thru e.g. a batchjob documents the file-equation in
> $STDLIST:
>
> :file soandso;dev=nnnn,7,1
>
> - Still all lists are printed twice...
>
> Please note: This goes ONLY for e3000 prints - not for PC-prints.
> Printing from e.g. MS Word acts normally: One copy ordered, one copy
> printed.
>
> Note, too, that lots of other LaserJets are printing very well thru the
> same NPCONFIG.
>
> A defective printer or a defective JD-card would seem probable - but
> then the PC print should print twice as well.
>
> I haven't found any entries in the system logfiles
>
> Any good ideas are much appreciated!
>
> Thank you.
>
> With kind regards,
>
> Hans
> ScanConsult IT-Partners
>
> * To join/leave the list, search archives, change list settings, *
> * etc., please visit http://raven.utc.edu/archives/hp3000-l.html *
>

* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *