Fellow listmembers:

I've been trying to successfully configure a 2345A DTC for our credit union's new branch.  I configured it in NMMGR, validated it (it validated and added successfully).  However, after connecting it to one of our hubs via RJ45 and 13-pin transciever and turning it on, no lights come on at either the hub or transciever end (DTC passes self-test with no problems). 

After changing various parameters (transciever, cable, hub port, jumper on processor  card is set to rows B and C for Thicklan connection) I setup another (working) DTC  using the same NMMGR configuration (deleting old one and creating new one with 2nd DTC's LAN address, natch).  This time, the hub port and transciever lights light up, all appears normal, but DTC goes C1 after timing out during download attempt.  Once again, tried changing various parameters...no success.  This second DTC worked fine at one of our branches during disaster recovery testing.

 Blew the dust off a '91 vintage DTC manual which described a method to access the DTC Diagnostics program via local terminal connected to board 0, port 0, but doing CTRL-P as instructed does nothing...I tried to setup the terminal according to the manual's outlined procedure as closely as possible,but they don't appear to have been written for a 700/92 terminal; perhaps there are additional parameters that need to be adjusted.

At this point, I am completely stumped!  Any help from some of the DTC/networking gurus out there would be greatly appreciated!

Thanks in advance,


Paul Cesario
Members1st Federal Credit Union
Mechanicsburg, PA. 17055
[log in to unmask]
http://www.members1st.org