You must bridge the MAC addresses across all the router interfaces.  There
were some postings on this in 1998.   Check the archives.

Eucaristo,
Tom Genute
Phone:  (212) 437-1744
Pager:   (888) 778-7121


                -----Original Message-----
                From:   Larry Barnes [mailto:[log in to unmask]]
                Sent:   Friday, February 11, 2000 5:26 PM
                To:     [log in to unmask]
                Subject:        DTC's on Lan using Cisco Routers

                I'm currently testing a network setup using Cisco routers
and switches,
                and CSU/DSU's (csu/dsu are not cisco).

                We have successfully testing the network connecting a pc to
the HP3000.
                When the DTC is cirectly connect to the HP3000 via ether-net
the DTC's
                configurations is successfully downloaded.  But when we
place the DTC on
                the other side of the network the HP3000 can't find the DTC.

                If it sounds like I'm rambling I am!
                What must I do to make the HP3000 see the DTC when the
traffic passes
                thru the routers.

                --
                Larry Barnes
                Director of MIS
                Mitek Corp.
                4545 E. Baseline Rd.
                Phoenix, AZ 85040
                [log in to unmask]