Tracy,

On a simple network (like ours), there are basically three steps:

1.  Configure a TCP/IP address on the printer.

2.  On the HP 3000, edit (or create) the NPCONFIG.PUB.SYS file.  If you're creating your first printer, I believe they have a sample file.  Look for [log in to unmask] (I think).  Be sure to not place any spaces prior to the device number.

3.  Then, use IOCONFIG utility, and add the device, for example:

AD 81 PATH=NONE ID=HPTCPJD

When you're done with these steps, you just basically have to set your OUTFENCE, HEADOFF/HEADON, etc., and you're ready to print.  No shutdown should be necessary.

I've configured a number of printers this way. If you have any problems, give me a call at (301) 217-9623.

Good luck!
Tim Busche

----------
From:   Tracy Johnson[SMTP:[log in to unmask]]
Sent:   Tuesday, October 21, 1997 8:08 PM
To:     [log in to unmask]
Subject:        Network Printers... again

Wish I had saved the threads on how do you set up Network Printers with
the Jet Direct card...

I got an LJ4si with a JetDirect card on the LAN and and HP3000 with MPE/iX
5.5 ... where do I start?

Tracy Johnson
Minister of Propaganda, Justin Thyme Productions
[log in to unmask]
"Semper Pollus"
 ADC-2239-5531