With our DDS auto changer , a manually brought on line tape shows as ready in showdev, but after use, when a new tape is loaded but NOT yet used, the drive shows as AVAIL, but if you issue a store command, it comes on line by itself.
Regards,
John Pitman
-----Original Message-----
From: HP-3000 Systems Discussion [mailto:[log in to unmask]] On Behalf Of Brent Moore
Sent: Tuesday, 9 March 2010 1:27 AM
To: [log in to unmask]
Subject: [HP3000-L] I/O errors
I have an A500-200 running MPE/iX C.75.02. I had a DTL8000 that had a tape
jam I followed instructions to remove the tape but I think the drive was
messed up. So I called HP and had them ship a new DTL which I installed last
week. The system saw the drive, I was able to store to the drive and do a
listdir to the tape. The funny thing was when the tape was online and I do a
showdev it showed a status of Avail.
I have been looking at my logs and I am getting I/O Error's on the SCSI
controller (see attached) as well as Device 8.
After writing this I think I will try calling HP the problem there is you say
HP3000 and they ask you what is that but I will try. But I welcome any other
suggestions.
* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *
CAUTION: This message may contain privileged and confidential information intended only for the use of the addressee named above. If you are not the intended recipient of this message you are hereby notified that any use, dissemination, distribution or reproduction of this message is prohibited. If you have received this message in error please notify RYCO Hydraulics Pty. Ltd. immediately. Any views expressed in this message are those of the individual sender and may not necessarily reflect the views of RYCO Hydraulics Pty. Ltd.
* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *
|
