Subject: | |
From: | |
Reply To: | |
Date: | Thu, 3 Aug 2000 16:01:11 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Allan Chalmers wrote:
>
> I am trying to select trays on an LJ5N and have
> entered as follows in npconfig:
>
> 520 (network_address = 192.78.126.79
> pjl_supported=false
> banner_trailer=false
> data_tray = 2
> banner_header=false)
>
> No matter what I put in for this printer with an
> add-on tray, it still prints from the add-on and not
> from the original tray, marked "2".
The "data_tray" directive is wiped out by any subsequent setup or
environment file (and bear in mind, if no setup or environment, MPE
supplies you a landscape-mode 132 col x 66 line default) as they
generally begin with a hard reset, putting the printer back to default.
The "banner_tray" does work (no setup).
The alternative, as someone else replied, is to put the tray selection
PCL code in a setup file and use it. You will also have to experiment
with the PCL codes and your particular printer's trays; it isn't exactly
intuitive which numbers go with which trays.
Jeff Kell <[log in to unmask]>
|
|
|