Michael
Did you buy the necessary software for the card? We recently added a BT100
card to a 9x9 box and had to by the hardware and software, even though we
are on 7.5.
Bob Schlosser
Technical Consultant
The Support Group
Austin, TX
(512) 284-3733 cell
(512) 266-4400 office
(800) 798-9862 Support
CONFIDENTIAL: This message is intended only for the use of the individual
to whom it is addressed. It contains information which may be privileged,
confidential and exempt from disclosure under applicable law. Any views or
opinions presented are solely those of the sender and do not necessarily
represent those of Blanket Enterprises, Inc. or its subsidiaries unless
otherwise specifically stated. If the reader of this message is not the
intended recipient, the reader is hereby notified that any dissemination,
distribution or copying of this communication is strictly prohibited. If
you have received this communication in error, please inform the sender via
email or call us at (800) 798-9862.
-----Original Message-----
From: HP-3000 Systems Discussion [mailto:[log in to unmask]] On Behalf
Of Michael
Sent: Thursday, February 18, 2010 2:40 PM
To: [log in to unmask]
Subject: [HP3000-L] BT100 Install, DCC error
I thought MPE 7.0 pp2 had all the necessary patches for the BT100 to
function properly, correct me if I am wrong.
On a 9x9 (K-Box) running MPE 7.0 pp2:
Installed the BT100 board
Ran mapper found the bt100 to be at /10/4/16.
NMMGR, modified both DTSLINK & NS type and path.
Validate both NS and DTS, OK.
REBOOT, with the following error:
DCC ERROR 15-3 link error status FBFD032C LLIO PATH (DCCERR 19)
DCC START ERROR
So, what I am I missing?
Any clues much appreciated.
Mike.
* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *
* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *
|
