Hello,

I don't know what version of the OS you are using, but you if you are on
Base 7.0, may need to install patch CONGD15. There were some problems with
modem operations on the console driver on Release 7.0.

Try using the port in the GSP mode. If you can connect using that mode that
would confirm a driver problem. Configure the port in the GSP for BELL
protocol, 9600 Baud.

I can't guarentee that your modem will work on the N4000 because the GSP
sends configuration info to the modem that your modem may not recognize.

John Spitzer
CSY LAB

"Beghein Johan" <[log in to unmask]> wrote in message
news:VNmP7.12$qg6.852@nreader2.kpnqwest.net...
> Hello,
>
> On my N4000, I try to put a modem so the RC can log into my system.
>
> On my modem, I don't have the DTR signal, so the modem doesn't hook up.
> If I look in GSP, the MS command gives me a signal on DTR/108, I use the
> cable delivered with my system, but the signal isn't on the leds of my
modem
> ( The modem works on other stuff ).
>
> Also, I did the ER command to allow a Session on this port.
>
> In NMMGR, the port is configured on ldev 21, 9600 bauds, US modem, Parity
> None.
>
> Altough I'm in Belgium, we always had the modem configured as US on the
> previous systems.
>
> Any idea ?
>
> Thanks.
>
> Beghein Johan.
> [log in to unmask]
>
>
>
>

* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *