In one of the power patches, there is a change to the PAUSE command that
will allow you to pause a job until another job finishes.  Now whether
the job completes successfully is a different matter.  If your system
does not have that PP on it, you could use message files to handle this.
I have a command file that will help.  Let me know if this interests
you.

Later.

        -----Original Message-----
        From:   Simonsen, Larry [SMTP:[log in to unmask]]
        Sent:   Monday, October 19, 1998 8:17 PM
        To:     [log in to unmask]
        Subject:        pause while job executing

        I seem to remember a command which would allow one job to wait
for
        another job to complete.  I thought that it was the pause
command but, I
        cannot find the syntax for this.
        can some one point me into the right cave for this?


------------------------------------------------------------------------
        Larry Simonsen          Phone: 801-489-2450
        Flowserve Corporation   Fax: 801-491-1750
        PO Box 2200             http://www.flowserve.com
        Springville, UT 84663   e-mail: [log in to unmask]

------------------------------------------------------------------------