For all,
The latest CSTM patches are
MPE/iX 6.5 == ODINX19A
MPE/iX 7.0 == ODINX19B
MPE/iX 7.5 == ODINX19C
-Craig
--- On Mon, 12/20/10, Dan Barnes <[log in to unmask]> wrote:
> From: Dan Barnes <[log in to unmask]>
> Subject: STM System Manager Problem
> To: [log in to unmask]
> Date: Monday, December 20, 2010, 7:30 AM
> Hi All,
>
> This is a 989/450 HPe3000 running MPE/iX 7.0 and is patched
> up to date for quite some time now.
>
> I have a nightly job that runs on all of our systems to
> monitor hardware. The job blew up on Sunday and again
> this morning. Upon initial investigation, I found that
> CSTM would not load correctly, and then found the following
> on the console:
>
> STM Diagnostic Monitor already stopped.
>
> STM system manager started
> STM system manager EXIT due to initialization failure
>
> I have looked thru the archives, but only got 1 hit from
> 2005 and no helpful information.
>
> I have tried stopping and restarting STM (STMSHUT.DIAG.SYS
> STMSTART.DIAG.SYS) to no avail.
>
> There have been no network changes, I found nothing of
> interest in SYSLOG, and am not sure where else to look to
> ascertain what is going wrong. Below is what I get
> when I go into CSTM.
>
> TIA,
> Dan
>
> - - - - - - - -
>
> HP1659:cstm
> CSTM B8343AA.75.11 Version created FRI, MAY 9,
> 2008 8:01 AM
> Running Command File (/usr/sbin/stm/ui/config/.stmrc).
>
>
> This operation may take approximately one minute.
>
> An unexpected error was encountered while attempting to
> retrieve the
> host info for hostname (hp1659.mmm.com).
> This could be due to either of the following conditions:
>
>
> 1) The support tool daemon "diagmond" may not be running on
> that system.
> Use the STM Startup command (in the administration menu
> under the
> file menu.)
>
>
> 2) The IP address for the system may be invalid or may not
> be associated
> with a valid host. Use a valid IP address.
>
>
> 3) Networking may be incorrectly configured on one of the
> systems involved.
> Verify networking by comparing 'nslookup `hostname`' with
> the output
> of ifconfig of the LANs identified by lanscan.
>
>
> More details may be available in the System Activity Log
> and in the
> syslog on that system.
> It may be necessary to access these using the Local Unit
> Under Test (UUT) logs
> (in the administration menu under the file menu.)
> Please Refer to the UI Activity Log for more details.
>
> An unexpected error was encountered while attempting to
> retrieve the
> host info for hostname (hp1659.mmm.com).
> This could be due to either of the following conditions:
>
>
> 1) The support tool daemon "diagmond" may not be running on
> that system.
> Use the STM Startup command (in the administration menu
> under the
> file menu.)
>
>
> 2) The IP address for the system may be invalid or may not
> be associated
> with a valid host. Use a valid IP address.
>
>
> 3) Networking may be incorrectly configured on one of the
> systems involved.
> Verify networking by comparing 'nslookup `hostname`' with
> the output
> of ifconfig of the LANs identified by lanscan.
>
>
> More details may be available in the System Activity Log
> and in the
> syslog on that system.
> It may be necessary to access these using the Local Unit
> Under Test (UUT) logs
> (in the
> administration menu under the file menu.)
> Please Refer to the UI Activity Log for more details.
>
> -- Information --
> MPE/iX Support Tools Manager -- Product Number
> B8343AA, Version A.75.11
> (C) Copyright Hewlett Packard Co. 1995,2006
> All Rights Reserved
>
> Use of this program is subject to the licensing
> restrictions described
> in "Help-->On Version". HP shall not be liable for
> any damages resulting
> from misuse or unauthorized use of this program.
>
> cstm>
>
>
> Dan Barnes
> LCI-Lawinger Consulting
> 106 Central Avenue, Suite A
> Osseo, MN, 55369-1243
> Tel: 763-425-1639 :: Fax: 763-425-5483
> Cell: 612-240-2136 :: Pager: 952-394-0132
> [log in to unmask]
> [log in to unmask]
>
> * To join/leave the list, search archives, change list
> settings, *
> * etc., please visit http://raven.utc.edu/archives/hp3000-l.html *
>
* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *
|
