Are you sure you've got the primary path correct?

Also, it's critical that the firmware on the FWSCSI card that your 
disk array is attached to is version 3636 or higher (3728 is best).




At 12:51 AM 2010-11-23, Greg Terterian wrote:
>Ok, I think I figured out the 1st part of the problem (one of the 
>4GB disk drives was bad).  I replaced it with 9GB and it seems 
>everything looks ok.  However, when I do an Install from SYSGEN 
>tape, it starts MPE/iX launch facility and then it displays:
>
>Install C.39.06 Copyright (c) hewlett packard
>Install -- MPE/IX disk image builder.
>Initialize genesis - ver bid1: <<pci 2.1601>>
>Date and Time
>Initialize genesis = Ready to configure I/O
>{COM}1 12 1 12
>Initialize memory manager completed.
>Beginning Install...
>
>It sits there and does nothing.... I waited for over 30 minutes...
>tape does not flash and no actiivity lights on the disk array...
>
>Please help!
>Thanks a million
>Dave
>
>
>
>
>* To join/leave the list, search archives, change list settings, *
>* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *

-------------------------------------------------------------------------------------------------
Gilles Schipper
GSA Inc.
HP System Administration Specialists
300 John Street, Box 87651   Thornhill, ON Canada L3T 7R4
Tel: 416.702.7900
email:  [log in to unmask]  web: http://www.gsainc.com
-------------------------------------------------------------------------------------------------

* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *