On 16 Nov 2005 at 14:24, Johnson, Tracy wrote:

> #1 Did you configure (add or modify) the LOOP?
> 
> #2 Is the network cable plugged in?
> 
> #3 If you used a transceiver, are the dip switches set right?
> (LEDs on and RX/TX blinking?)

I am not trying to reach the box from the outside yet, I am still 
trying to run ping from a serial console session to verify that the 
IP address is assigned.  I believe that I should get a local 
response whether the network transciever and cable are attached or 
not.  

I assume that have misconfigured something so I am now looking 
through the NMMGR to see if I have mistyped an entry.

Regards,
Jim

--   
     *** e-mail is not a secure channel ***
mailto:byrnejb.<token>@harte-lyne.ca
James B. Byrne                Harte & Lyne Limited
vox: +1 905 561 1241          9 Brockley Drive
fax: +1 905 561 0757          Hamilton, Ontario
<token> = hal                 Canada L8E 3C3

* To join/leave the list, search archives, change list settings, *
* etc., please visit http://raven.utc.edu/archives/hp3000-l.html *