Hello,

I need to run my disk defrag utility, so I followed the instructions to
check the
status of the file system with FSCHECK.  According to the output from
FSCHECK (see below), there are two files "with no directory entry".
They are AUTOINST.INSTALL.SYS and AICAT000.INSTALL.SYS.  Also it found a

"$GROUP/FILESET : PUB.SYS  **UFID NOT IN LABEL TBL".

I called the HPRC, and the engineer told me to run FSCHECK again and do
the following:

checklabel all;fix
checkdirc all;fix
checkextents all

Someone else recommended that I do this to fix the files with no label
entries:

copy autoinst.install.sys,autoi.install.sys
purge autoinst.install.sys
rename autoi.install.sys

Before I do either I'd like to check with the folks on this list.  Any
advice/recommendations would be appreciated. Thanks.
--
Tim
-----------------------------------------------------------------------------------

%run fscheck.mpexl.telesup
FSCHECK, A.05.00. (C) Hewlett-Packard Co., 1987. All rights reserved.
fscheck: checkdirc all ignore

Checking the directory on volume set: MPEXL_SYSTEM_VOLUME_SET

PASS 1. Scan MVT and build Label Table Cache for MPEXL_SYSTEM_VOLUME_SET

PASS 2. Scan Directory on MPEXL_SYSTEM_VOLUME_SET
PASS 3. Scan Label Table Cache for missing files.
FOUND FILE:AUTOINST.INSTALL.SYS   AT 000000B1.00029720   WITH NO
DIRECTORY ENTRY
.
CREATOR :MANAGER SYS
*Verify: 1) Insert into directory, 2) Deallocate file label, 3) Ignore
?e
*Error: Invalid Response. Please answer with 1, 2, or 3.
*Verify: 1) Insert into directory, 2) Deallocate file label, 3) Ignore
?3

FOUND FILE:AICAT000.INSTALL.SYS   AT 000000B1.00029D20   WITH NO
DIRECTORY ENTRY
.
CREATOR :MANAGER SYS
*Verify: 1) Insert into directory, 2) Deallocate file label, 3) Ignore
?3


Checking the directory on volume set: PV_SET

PASS 1. Scan MVT and build Label Table Cache for PV_SET
PASS 2. Scan Directory on PV_SET
ENCOUNTERED $GROUP/FILESET : PUB.SYS
**UFID NOT IN LABEL TBL 05620001 31129D30 000048C4 62042466 0400DA05
*Verify: 2) Delete file,  3)Ignore ?3