Jean-Claude Cisse <[log in to unmask]> wrote:
 
>        Hello all,
>        I was trying to put an HP3000/918RX on our school network. But
>when I type this command (NSCONTROL START), I receive these messages:
> missing dadconfig.net.sys configuration file. (dserr 661)
> ns control command errors. (cierr 5400)
 
>        Also, after I've crossed validate the Network Transport, I tried to
>cross validate in sysgen by typing the following commands at the mpe prompt:
 
>        :sysgen
>        sysgen>io
>        io>exit
>        sysgen>exit
>        :
 
>  **Warning** can't get nmmgr info for file nmconfig.pub.sys.
>  dcc error: the nmconfig file must be verified inside nmmgr first.
 
The error about the dadconfig file is caused by not running the
network configuration job.  I believe it is called jconfig.net.sys or
something similar (sorry I can't verify the name from home).  Stream
this job and you should have no problems.
 
To verify the nmconfig file, you must run nmmgr.  Inside nmmgr there
is a function key labelled utility and within that screen there is a
validate function key.  Perform the first two validations (sorry, once
again I can't verify the names from home).  The first validates the
network configuration, and the second validates DTC and other system
systems.
 
You should shutdown the system and restart after performing these two
tasks.  When the system comes back up you should have no problems.
 
 
Roger Klump
Orion Group Software Engineers
[log in to unmask]