Allan,

You need to specify a "setup_file" in the "npconfig" for printer 520.
In the "setup_file" (ours are LJ5SI1 and LJ5SI2) add a line for the
tray selection should be something like "<esc>&l8H", see your printer
manual for the PCL code.                 ^^^^^ ^
                                     this is    this is
                                     the ESC    alpha
                                   character

Regards,

Sam Knight

Allan Chalmers wrote:
>
> I am trying to select trays on an LJ5N and have
> entered as follows in npconfig:
>
> 520 (network_address = 192.78.126.79
> pjl_supported=false
> banner_trailer=false
> data_tray = 2
> banner_header=false)                   #Scheduling
> LJ5N
>
> No matter what I put in for this printer with an
> add-on tray, it still prints from the add-on and not
> from the original tray, marked "2".  The manual says
> that "1" is the default tray, then "2", unless a "3"
> tray is added, then it becomes the default.
>
> I am using NPSAMP1 and 2 in PUB as a guide.
>
> Any advice on this?  Response Center has not been too
> helpful.
>
> __________________________________________________
> Do You Yahoo!?
> Kick off your party with Yahoo! Invites.
> http://invites.yahoo.com/