Hi,

I'm printing from HP3000 to an old LJ 3Si Postcript here.  Only way I found
to make it work correctly was to switch from postcript to PCL in setup_file.
Here is command I inserted in line following  [esc]E in a setup file I
created for it:

    [esc]%-12345X@PJL ENTER LANGUAGE=PCL[lf][cr]

Escape sequence to set paper size to A4 is then

    [esc]&l26A

In those two lines, replace [esc] by escape character, [lf] by linefeed
character and [cr] by carriage return character.

Hope it will help.
--
==================================================
Denis St-Amand (Remove "removeit." from email address)
==================================================
"Steve Belkacem" <[log in to unmask]> wrote in message
news:99aofk0u7b@enews1.newsguy.com...
> Hi all,
>
> Has anyone had any luck with configuring a laserjet
> Laserjet 4SI/MX  (with Postscript Level 2)with
> Papersize A4. Below is what I currently have but I
> can't get anything to print.
>
>
> 1200        (network_address=xx.xx.xx.xx
>            snmp_enabled=false
>             jam_recovery=TRUE
>             pjl_supported=true)
>
>
> Thanks in Advance
>
> Steve
>
> ____________________________________________________________
> Do You Yahoo!?
> Get your free @yahoo.co.uk address at http://mail.yahoo.co.uk
> or your free @yahoo.ie address at http://mail.yahoo.ie
>