Roy Tejares writes:

>Our HP 3000 is currently connected to the network thru 10Base2 (coax)
>cable. Our network guys want to use the AUI port instead (as opposed to
the
>ThinEthernet port) as they say it will allow them 'to connect all units
>over twisted pair to a hub thus improving troubleshooting in case they had
>to'. What would be the impact to the system of these changes and that do i
>have to reconfigure anything in the system?. Any input is greatly
>appreciated.

We did just this on our 918's.  It was a simple change for us.  Shut the 
system down, pull the MFIO board, swap a jumper, re-install MFIO board, 
and away you go.

We have noticed no impact, nor did we need to reconfig anything.  Of
course, 
your system may be different.

Jim Phillips                            Manager of Information Systems
Voice: (330) 527-2124                   Therm-O-Link, Inc.
  Fax: (330) 527-2123                   PO Box 285; 10513 Freedom St.
Email: [log in to unmask]       Garrettsville, Ohio  44231