In article <[log in to unmask]>,
  Jim Wowchuk <[log in to unmask]> wrote:
] Subject:      Re: Dual Session Terminals
]
] Mark E. Fabian writes:
] >Is there a way to get two sessions running simultaneously
] >under MPE? Which terminal can be used? I know that HP use
] >to make a terminal (the 2626W I think)that could do this.
] >Can a 700/92 or 700/96 do the same job?
] >All suggestions welcome.
]
] Of course, with a 700/92 you can plug into both the datacomm port and the
] print port then alternate between by using selecting the Config keys, then
] Terminal Config.  The Datacomm/ExtDev field will toggle between Port1/Port2
] and Port2/Port1 (respectively).  Cheap and nasty but works in a pinch!
 
Works quite well actually.  I used a 1200 baud modem on printer port to
call a PBX, then tell it to spill it's (configuration) guts.  Output (by
using LOG BOTTOM) sent to FCOPY {from=$STDINX; . . .} on to a disk file.
I guess I could've wired 'em together, but then again . . .
 
--
Regards  --  Tony B. Shepherd  --  [log in to unmask]