Oops, nobody asked about putting a tape online, did they...(it's Friday)

What I meant to answer was the auto reply...

If you have the program on your system you can do this.

RUN AUTOREP.UTIL.SYS;PARM=7

If you want to turn it back off, use -7.

-----Original Message-----
From: Newton, Ernie
Sent: Friday, August 04, 2000 11:55 AM
To: [log in to unmask]
Subject: RE: [HP3000-L] Help - Setting AutoReply & AutoEject


Actually, you can put the tape online by using devctrl also...

DEVCTRL.MPEXL.TELESUP 7;LOAD=ONLINE

That'll do it...

-----Original Message-----
From: Newton, Tony [mailto:[log in to unmask]]
Sent: Friday, August 04, 2000 11:48 AM
To: [log in to unmask]
Subject: Re: [HP3000-L] Help - Setting AutoReply & AutoEject


Cathy,

Part 1:
You set up devices for autoreply inside of sysgen.  You can do something
similar to the following.
:Sysgen
sysgen> IO
io>md 7;mode=autoreply
io>hold
io>exit
sysgen>keep
sysgen>exit

Part 2:
You can specify a device to autoeject by using DEVCTRL.MPEXL.TELESUP.
echo *******************  DEVCTRL SYNTAX ERROR  ***********************
echo
echo Usage Syntax:
echo DEVCTRL LDev COMPRESSION=Compress EJECT=Eject LOAD=Load where
echo   LDev - Logical Device Number (Required)
echo    Compress - [Enable | Disable | Nochange]
echo    Eject    - [Enable | Disable | Nochange]
echo    Load     - [Online | Offline | Nochange]
echo
echo *******************  DEVCTRL SYNTAX ERROR  ***********************

Hope that this helps.
____
Tony Newton  |  [log in to unmask]
HP Systems Admin  |  (503) 574-5831
Providence Health Plan  |  www.providence.org



> -----Original Message-----
> From: Cathy Gunderson [SMTP:[log in to unmask]]
> Sent: Friday, August 04, 2000 11:38 AM
> To:   [log in to unmask]
> Subject:      [HP3000-L] Help - Setting AutoReply & AutoEject
>
> I need help on how to set the Auto Reply and Auto Eject for LDEV 7 on.  I
> believe this is done with a SET command but can't remember the format of
> the
> command.  We are on MPE/iX 6.0.
> Thanks.
>
> Cathy