Zane Howe writes:
 
[snip]
 
> Now I have another problem as follows:
>
> :RUN REPORT
>
> REPORT/V         HP32245A.06.02 - (C) Hewlett-Packard Co. 198
>
> *ERROR: CATREAD FAILURE  6 (SET#   12,MSG#   20)(SYSTEM 17)
> **** PROGRAM ERROR #18 :PROCESS QUIT .PARAM = 6
> ABORT: REPORT.PUB.SYS
> NM SYS   a.009d8180 dbg_abort_trace+$24
>    CM SYS  % 213.7323   SWITCH'TO'NM'+%4        SUSER1
>    CM PROG %   3.2261   GETMESSAGE+%570         ERROR
>
> PROGRAM TERMINATED IN AN ERROR STATE.  (CIERR 976)
>
 
[snip]
 
> =========================================================================
> Zane Howe                          email: [log in to unmask]
> Albertson College of Idaho         Phone: (208)459-5409
> Director of Information Systems
> 2112 Cleveland
> Caldwell, ID 83605
> =========================================================================
 
Zane,
    This error is with CATREAD not CATOPEN. (you're getting further)
My Orbit (*minor plug*) Pocket Guide says that CATOPEN error 6 is
"user buffer overflow".  I'm only guessing, but it sounds like your
RAPID000 file may not be the same version matching the TRANCOMP
program.  Were both files from the other system?  Were they working
there?
    You might want to give the Response Center a call since I'm at IPROF
and my resources (and response time) are limited.
Rich
--
______________________________________________________________________
________ Dynamic Information Systems Corp.   |
\!DISC / Rich Trapp                          | My opinions are my own.
 \    /  OMNIDEX Product Manager - IMAGE/SQL | With any luck they're
  \  /   Phone : 303 444-4000                | correct ;-)
   \/    E-mail: [log in to unmask]                |
----------------------------------------------------------------------